May I know how can configure NTP Server and client in a LAN. We have one Layer 3 Cisco (3560) switch and tree layer 2 ( 2960 ). I want one of them work as NTP server and others NTP client and sync true Time.
It means the 3560 can be used as an NTP server by the 2960 switches.
But because the 3560 has no hardware clock the 3560 cannot be an NTP master. This means that the 3560 must have a reliable time source from some other device. If you can do this then you can then make the 2960 switches clients of the 3560.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...