Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

permitting specified commands only

Hi,

We have TACACS enabled in our routers. I wanted to restrict user access to only particular commands. I am providing those commands below.

Router#term len 0

Router#sh clock

Router#sh ip int br

Router#sh env all

Router#sh int s0/0

Router#sh int s0/1

Router#ping 10.30.250.137

Router#conf t

Router(config)#int se0/0

Router(config-if)#no backup int br0/0

Router#exit

Router#isdn call int bri 0/0 22861600

Router#sh isdn a

Router#sh isdn status

Router(config)#int se0/0

Router(config-if)#backup int bri0/0

Router#sh int bri0/0

Router#sh run

Nothing more than these commands should be allowed for configuration. Can someone advice me for required configuration in Router as well as cisco ACS.

Regards

SKRAO

1 REPLY
Bronze

Re: permitting specified commands only

hi

one way of doing that job without relying on any AAA software , is to create a local user name and give that user a certain privilege level IE 7, move all the commands you ve typed above to that level

and it will work fine

HTH

DO rate if it does help

103
Views
0
Helpful
1
Replies