cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
598
Views
0
Helpful
2
Replies

Ping through VPN

bruno.lach
Level 1
Level 1

Hi,

I have two routers Rv082. I made a gateway to gateway tunnel between the two of them. From a computer behind my first router I can ping my other router.

But when I try the same thing from a computer behind my second router, I cannot ping the first router.

Do you have any idea of the problem.

Thank you

2 Replies 2

platinum_jem
Level 1
Level 1

Some info on your configurations, plus IP addresses would aid in the troubleshoot.

The Tunel configurations are :

Tunel Name : Test

Interface : Wan1

Enable : checked

Local Security Gateway Type : Ip Only

IP Address : XXX.XXX.XXX.XXX

Local Security Group Type : Subnet

IP address : 10.0.0.0

Subnet Mask : 255.255.255.0

Remote Security Gateway Type : Ip Only

IP Address : XXX.XXX.XXX.XXX

Remote Security Group Type : Subnet

IP address : 192.168.0.0

Subnet Mask : 255.255.255.0

Keying Mode : IKE with Preshared key

Phase1 DH Group : Group1

Phase1 Encryption: DES

Phase1 Authentication : MD5

Phase1 SA Life Time : 2800 seconds

Perfect Forward Secrecy : checked

Phase2 DH Group : Group1

Phase2 Encryption: DES

Phase2 Authentication : MD5

Phase2 SA Life Time : 3600 seconds

Preshared Key : test

In the advanced section I checked the following options :

NetBIOS broadcast

Keep-Alive

Aggressive Mode

I have try this three options checked and unchecked.

I hope this can help!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card