Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Pix 501 that don't allow outside connections

I have a pix correctly configured to make outbound connections from the external address. I have configured a nat pool to allow the internal hosts make outbound connections using NAT. But my problem is that when an internal host try to access to any external addresses, it is unable. However the external ip of the pix can access without any problem. Any suggestions ? Thanks

2 REPLIES
Silver

Re: Pix 501 that don't allow outside connections

To start from scratch, did you configure conduits or Access-lists also?

New Member

Re: Pix 501 that don't allow outside connections

I don't have any conduit or static access configured. But I have some access-list configured for vpn connection. Only for that.

125
Views
0
Helpful
2
Replies
CreatePlease to create content