PIX 501 to Remote Vendor- Nat to external address

[smolz]

I have a pix 501 (6.3(5)) that I need to be able to use to connect to remote vendors with. I also need to have the internal host on my side be nat'd to an address in my outside interface range so the vendors will connect to that device as the external address through the vpn tunnel.

Can anyone help me by posting a full configuration please?

[mvsheik123]

Hi,

Based on existing gear & infrastructre at temote vendor sites you may want to go with Lan to Lan tunnel or Remote access to your PIX. Check the license options on your pix.See the below link for various configuration scenarios...

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/prod_configuration_examples_list.html

hth

MS

**Rate helpful postings**

[smolz]

I should have been clearer, I want to have an ipsec lan to lan tunnel between the 2 sites with the remote side accessing my internal resource using the nat'd external address of the resource.