Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX change management software

Hi, i have Cisco works LMS3.0,

i have added all routers switches, and after every 24 hours, all changes to my routers switches, i get that via email,

but i dont see any change report of cisco pix firewall.

dont LMS3.0 support firewall changes ? am i missing some thing? or i need some other software to do that?

3 REPLIES

Re: PIX change management software

The PIX/ASA etc. firewalls are supported. We have setup RME to report changes in one of our customer's FWSM blade.

This is also mentioned on the following link: (Just search for 'Pix' on the page)

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/3.1/device_support/table/lms31sdt.html

Regards

Farrukh

New Member

Re: PIX change management software

Thank you for the information, But i dont get change report , though devices are added in same way as of Routers,

Do i need to do any additional confoguration on firewall, except SNMP string and specifying IP address of server running LMS and its interface name inside in my case?

in my PIX i have this confoguration, router confoguration change report comes fine, with same set of information configured in router/switches.

snmp-server host inside x.x.x.x community abcd

snmp-server community abcd

Re: PIX change management software

Do one thing, go to the Device Center >> Select the 'Firewall' and then click on 'View Config' Is RME collecting any

configs at all for your firewall?  You can also check this from RME directly.

Regards

Farrukh

482
Views
0
Helpful
3
Replies