Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Pix to Pix VPN with no LAN

Same old story, but I've been unable to resolve. Client that we've recently taken over with 501 to 506 VPN but can't access LAN resources from one side to the other. (Ping, browse, telnet...). Both configs attached. Thanks in advance.

2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: Pix to Pix VPN with no LAN

You have encr/decr on both sides, are you sure BOTH sides cannot access each other?

Regards

Farrukh

Re: Pix to Pix VPN with no LAN

Great to know you have it working now :)

Please rate helpful posts.

Regards

Farrukh

6 REPLIES

Re: Pix to Pix VPN with no LAN

Can you post the following from both sides after establishing the tunnel and doing a continuous ping:

show crypto isakmp sa

show crypto ipsec sa

Also have a look at:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080094761.shtml

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_tech_note09186a008009448c.shtml

Regards

Farrukh

New Member

Re: Pix to Pix VPN with no LAN

Thanks, output attached. I had already reviewed both of the mentioned links.

Re: Pix to Pix VPN with no LAN

You have encr/decr on both sides, are you sure BOTH sides cannot access each other?

Regards

Farrukh

New Member

Re: Pix to Pix VPN with no LAN

Thanks, happs links took care of it. It's always an ACL!! Thanks again guys.

Re: Pix to Pix VPN with no LAN

Great to know you have it working now :)

Please rate helpful posts.

Regards

Farrukh

Cisco Employee

Re: Pix to Pix VPN with no LAN

Doesnt look like a vpn problem anymore, just make sure the hosts in question do not have a Firewall installed.

138
Views
0
Helpful
6
Replies