Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

privilege level question

Hi there

my customer ask me to provide him a priv. level where he could use all "crypto" commands in config mode. Is this possible without writing each command line by line into the config?

something like this

priviliege configure level 1 crypto *

IOS does unfortunately not undestand the * :-(

my second question, my CU would like to reconfigure all preshared key's by him self all the time.

i try this one

privilege configure level 1 crypto isakmp key

i can enter the command with a keystring but i can't enter the peer address at the end of the line. Does anybody now how to solve this issue?

I am running IOS 12.3 T4

121
Views
0
Helpful
0
Replies
CreatePlease to create content