Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Problems with VPN client (4.0) for Linux over ppp0

Cisco VPN client v. 4.0 for Linux (Mandrake 9.1) works perfectly with Ethernet interface, but after I dial VPN concentrator 3005, routing installs correctly to ppp0 (VPN conc. is reachable), but IKE is not exchanging (VPN client debug shows that it is still using Ethernet encapsulation instead of Point-to-Point). Additionally after I run vpnclient executable, the connection to VPN concentrator is lost until vpnclient exits (with failure message).

Thanks for any suggestions or the solution in advance

Adam

1 REPLY
New Member

Re: Problems with VPN client (4.0) for Linux over ppp0

Adam,

Try shutting down the ethernet interface.

-rheda

141
Views
0
Helpful
1
Replies
CreatePlease to create content