Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

remote dmz lan routing through vpn tunnel

Please see attached visio diagram

I have a 50 site MPLS cloud running BGP

At one of my remote sites, I have a 2821 router and PIX running ospf

When the MPLS/BGP drops, the remote router brings up a VPN connection to the host.

The host router gets routing update via PIX of routes to the remote site over vpn for the directly connected networks, the 10.200.101.x and the 10.1.27.x,

but not the remote PIX's DMZ 10.200.100.x network.

#sh ip route ospf

10.0.0.0/8 is variably subnetted, 104 subnets, 3 masks

O 10.200.100.0/24 [110/11] via 10.200.101.1, 1w2d, FastEthernet0/1/0

How do I get the host router to see the DMZ network at remote site?

Remote router ACL for VPN tunnel

access-list 102 permit ip 10.1.27.0 0.0.0.255 any

access-list 102 permit ip 10.200.101.0 0.0.0.255 any

access-list 102 permit ip 10.200.100.0 0.0.0.255 any

access-list 111 deny ip 10.1.0.0 0.0.255.255 10.1.100.0 0.0.0.255

access-list 111 deny ip 10.1.0.0 0.0.255.255 10.1.101.0 0.0.0.255

access-list 111 deny ip 10.200.100.0 0.0.0.255 10.1.100.0 0.0.0.255

access-list 111 deny ip 10.200.100.0 0.0.0.255 10.1.101.0 0.0.0.255

access-list 111 deny ip 10.200.101.0 0.0.0.255 10.1.100.0 0.0.0.255

access-list 111 deny ip 10.200.101.0 0.0.0.255 10.1.101.0 0.0.0.255

access-list 111 permit ip 10.1.0.0 0.0.255.255 any

access-list 111 permit ip 10.200.100.0 0.0.0.255 any

access-list 111 permit ip 10.200.101.0 0.0.0.255 any

Thanks,

Bob

1 REPLY
Silver

Re: remote dmz lan routing through vpn tunnel

Please recheck your ACL and your running config of your device.

307
Views
0
Helpful
1
Replies
CreatePlease to create content