Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Router logging syslog problem

Hi,

the router is configured to sent logging messages to syslog servers. It seems OK, but nothing is logged on the syslog servers.

If i do debugging on the router, or go in config mode and exit, the output messages are sent to the syslog server.

I dont understand this, where is the mistake.

Please help, thx in advance.

IZM_Nemport#debug ip routing

IP routing debugging is on

IZM_Nemport#

08-02-2013 01:50:39 Local7.Debug 10.0.7.1 5279: 005276: Aug  2 01:50:39.765 PCTime: RT: NET-RED 0.0.0.0/0

08-02-2013 01:48:44 Local7.Notice 10.0.7.1 5278: 005275: Aug  2 01:48:44.636 PCTime: %SYS-5-CONFIG_I: Configured from console by barkon on vty0 (95.8.156.3)

logging trap debugging

logging source-interface Vlan1

logging 10.0.1.26

logging 10.0.12.1

logging 10.0.12.2

IZM_Nemport#sh logg
Syslog logging: enabled (1 messages dropped, 0 messages rate-limited,
                270 flushes, 0 overruns, xml disabled, filtering disabled)

No Active Message Discriminator.

No Inactive Message Discriminator.


    Console logging: disabled
    Monitor logging: disabled
    Buffer logging:  disabled, xml disabled,
                     filtering disabled
    Logging Exception size (4096 bytes)
    Count and timestamp logging messages: disabled
    Persistent logging: disabled

No active filter modules.

ESM: 0 messages dropped

    Trap logging: level debugging, 5277 message lines logged
        Logging to 10.0.1.26  (udp port 514,  audit disabled,
              authentication disabled, encryption disabled, link up),
              5277 message lines logged,
              0 message lines rate-limited,
              0 message lines dropped-by-MD,
              xml disabled, sequence number disabled
              filtering disabled
        Logging to 10.0.12.1  (udp port 514,  audit disabled,
              authentication disabled, encryption disabled, link up),
              5277 message lines logged,
              0 message lines rate-limited,
              0 message lines dropped-by-MD,
              xml disabled, sequence number disabled
              filtering disabled
        Logging to 10.0.12.2  (udp port 514,  audit disabled,
              authentication disabled, encryption disabled, link up),
              227 message lines logged,
              0 message lines rate-limited,
              0 message lines dropped-by-MD,
              xml disabled, sequence number disabled
              filtering disabled

Everyone's tags (1)
1271
Views
0
Helpful
0
Replies
CreatePlease to create content