Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Share Band to satellite client

I've a IP satellite network connected to Internet with a 7609 router. The bandwith allocated towards internet to satellite service amount to 2Mbps. I need to share the bandwith omogenous to my client. I give you a example:

Client 1: 9 connection towards internet

Client 2 : 1 connection towards internet

Then, bandwith allocated to Client 1 nearly 1 MBps and 1 MBps to Client 2. I need to share the band to clients, no to the connections.

Best regards.

1 REPLY
New Member

Re: Share Band to satellite client

You can config custom queue on the 7609 router on the outside interface to control the bandwith of two clients. each client share 50% bandwidth

I assmue that your client 1 ip address 1.1.1.1 client 2 ip address 2.2.2.2

access-list 1 permit 1.1.1.1

access-list 2 permit 2.2.2.2

queue-list 1 protocol ip 1 list 1

queue-list 1 protocol ip 2 list 2

queue-list 1 queue 1 byte-count 1000

queue-list 1 queue 2 byte-count 1000

interface serial 0

custom-queue-list 1

Here is a link how to do it:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/qos_c/qcprt2/qcdcq.htm

Best Regards,

276
Views
0
Helpful
1
Replies
CreatePlease login to create content