Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Show conn state and fix-ups

Can the show conn state command be used to monitor the connections for fix-up protocols?

1 REPLY
Silver

Re: Show conn state and fix-ups

Use the show port status command to display port status information.

show port status [mod_num[/port_num]]

Syntax Description

mod_num

(Optional) Number of the module.

/port_num

(Optional) Number of the port on the module.

This example shows how to display port status information for all ports:

Console> show port status

Port Name Status Vlan Level Duplex Speed Type

----- ------------------ ---------- ---------- ------ ------ ----- ------------

1/1 connected 523 normal half 100 100BaseTX

1/2 notconnect 1 normal half 100 100BaseTX

2/1 connected trunk normal half 400 Route Switch

3/1 notconnect trunk normal full 155 OC3 MMF ATM

5/1 notconnect 1 normal half 100 FDDI

5/2 notconnect 1 normal half 100 FDDI

266
Views
0
Helpful
1
Replies
CreatePlease to create content