Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Site to Site VPN with Dynamic IP

Hi, I am trying to setup a Cisco 1841 VPN tunnel for a Netgear FVS14 at a remote location. I have tried the SDM and everytime I submit the rules, the 1841 locks up and reboots. I can create a site to site VPN with dymanic IP (remote) correct?

2 REPLIES
Cisco Employee

Re: Site to Site VPN with Dynamic IP

Hello,

You can create the site to site VPN on a 1841 router. If the SDM allows you to create it or gives you the option then it means you should have the correct software to do so.

Do you have console access to the router.

IF so, can you log the console session to a file and try to do the same step. Capture the log file after it reboots and send them over to me.

Thanks

Gilbert

New Member

Re: Site to Site VPN with Dynamic IP

Gilbert,

I figured out that I was using the "step by step" wizard and used FastEthernet0/0 option and I think that is what was causing the lockup. I tried using the FastEthernet 0/1.217 and it configured but then I could not get outside the firewall. What am I doing wrong?

248
Views
0
Helpful
2
Replies