Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SNMP MIB for COPP in 7600 routers running 12.2(18)SXF4

Hi All,

My customer has deployed COPP initially to monitor the traffic flowing through the control plane. MRTG is been used to poll the CISCO-CLASS-BASED-QOS-MIB to collect the statistics obtained from the service-policy associated on the control-plane. Customer is not able to get the QOS post data bit rate values from the MIB, But was able to see though the show policy-map o/p ......Any help on this would be really appreciated ...Customer router is 7609 running MPLS with 12.2(18)SXF4.

Thanking You

Regards

Anantha Natarajan

2 REPLIES
Cisco Employee

Re: SNMP MIB for COPP in 7600 routers running 12.2(18)SXF4

Is the MIB reporting any value at all for the QOS post data bit rate such as 0 or no response at all?

New Member

Re: SNMP MIB for COPP in 7600 routers running 12.2(18)SXF4

Hi Davistan,

Sorry for delay in responding and thanks for the concern in this question. We were able to figure it out that the MIB object we used is not appropriate and we were able to get the right one .

Thanks

Regards

Anantha Natarajan

328
Views
0
Helpful
2
Replies