Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Spoke-to-spoke multicast problems

I have am trying to setup a network for a video surveillance system. The network is setup in a hub spoke configuration with multicast sources and receivers at all of the spokes. I am using a DMVPN configuration to encrypt tunnels from the spokes to the hubs and spokes to spokes. I am currently able to to get multicast traffic to the hub from all of the spokes but I can't see to get it from spoke-to-spoke. I don't know that much about configuring multicast so it may be a simple mistake on my part. I have attached configs from two of my spoke routers and my hub router. Thanks in advance for any help or suggestions.

5 REPLIES
New Member

Re: Spoke-to-spoke multicast problems

I don't see the configs attached. What hardware devices are you using for the hub and spoke ends?

New Member

Re: Spoke-to-spoke multicast problems

I accidentally submitted the post twice the original had the configs. They are attached below. The routers that I am using are 2821's for the spokes and a 7201 for the hub.

New Member

Re: Spoke-to-spoke multicast problems

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a008019d6f7.shtml

This looks like a sample of what you are trying to configure. A few specific differences between your config and the sample. Hope this helps.

New Member

Re: Spoke-to-spoke multicast problems

Thanks j.bourque for the response but I have DMVPN setup and it works. I can get unicast traffic between the spokes but not multicast. Multicast is not an area I know much about. I have tried several things that I have found online but am not sure how get the multicast from spoke to spoke. I am not even sure if I am setting multicast correctly on the routers. Most of the examples I have found are only for one source and several receivers and I have many of both.

Re: Spoke-to-spoke multicast problems

Perhaps a better design would be to integrate DMVPN with IOS Secure Multicast. Have a look at this:

http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6552/prod_qas0900aecd80471915.html

Regards

Farrukh

160
Views
0
Helpful
5
Replies
CreatePlease login to create content