Tacacs-server key working in some Cisco switches for AAA, but not in other switches???
Has anyone experienced this before? I am using Cisco ACS 5.2. I have a very simple word (no, not cisco ) for my tacacs-server key. I've used the same key within the ACS and on two other Cisco switches, and AAA is working fine between the two switches; however, in setting up the key via the ACS and on a third Cisco switch and using PuTTY, I'm getting the error of "Access Denied. Using keyboard-interactive authentication."
I've re-entered the simple tacacs key multiple times within the ACS and on the switch making sure to not fat finger or misspell it.
I don't think there is a problem with the AAA setup I have within the switches as all of the AAA configs are the same on every switch we have.
Any other possible ideas anyone can suggest?
-tacacs-server key is a simple key and is the same for every switch and within ACS
-AAA config is the same on every switch, so I do not believe it to be a AAA config issue
-Running config on switch that is not working is pretty much the same as the other two working switches
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...