Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

telnet usernmae and password

hi,

i have configured line vty with username password

but when i try to telnet that switch, it is only asking me password

i dont understand this

i am telneting from 4506e core switch to 2960 edge switch

  • Security Management
3 REPLIES
New Member

Re: telnet usernmae and password

Hi vishal patil,

Follow this simple command,

# line vty 0 4 - enables you to allocate a space up to 0 - 4 vty term over telnet session.

# login local - enables you to use the local username and password that you had created. (assuming you have already done created a username and password for your app). Don't use just login only or else it will prompts you just the way you have had.

# end

-onin.

New Member

telnet usernmae and password

hi,

i created local username and password and also done login local

but it only asks me the password while telneting

I am on core switch and telneting edge switch.

But when i telnet to core switch from putty, it asks me both username and password

didn't get this

New Member

Re: telnet usernmae and password

hi vishal patil,

try to check the configs to both of your SWs. use the command below and make sure that the results og line vty contains login local to both SWs or you may be post the sh run configs from both SWs so we may determine what causing the issue. (but basically the command above should fix your problem. the command below is for comparison between the two SWs' line vty configuration.)

# sh run | include line vty

-onin.

3045
Views
0
Helpful
3
Replies
This widget could not be displayed.