Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Trouble setting up VPN

Hi all. I'm pretty new to Cisco, and need to setup VPN access on a newly purchased 1811w router. Basically I need a setup where company employees can access their work desktop from home.

I have followed the instructions found here:

http://cisco.com/en/US/docs/routers/access/1800/1801/software/configuration/guide/vpnezvpn.html

and after following the instructions, I have the following config file (see attached).

Currently, when I issue the following command in the CLI: "show crypto ipsec client ezvpn", I get the following reply:

Eazy VPN Remote Phase: 6

Tunnel Name: ezvpnclient

Inside interface list:

Outside interface list: FastEthernet0

Current State: IDLE

Last Event: CRYPTO_SS_UNUSED

Save Password: Disallowed

Current EzVPN Peer: 10.10.20.5

My question(s) is - Does the config look like it is setup correctly, and if it does how do I test it (I've never used a VPN before.)

Thanks for the help.

1 REPLY
Bronze

Re: Trouble setting up VPN

The SSL VPN Client (SVC) provides a full tunnel for secure communications to the corporate internal network. You can configure access on a user by user basis, or you can create different WebVPN contexts into which you place one or more users.

SSL VPN or WebVPN technology is supported on these IOS router platforms:

870, 1811, 1841, 2801, 2811, 2821, 2851

3725, 3745, 3825, 3845, 7200, and 7301

http://www.cisco.com/en/US/products/ps6496/products_configuration_example09186a0080720346.shtml#diag

683
Views
0
Helpful
1
Replies
CreatePlease to create content