Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Unable to ADD ASA to CSM 4.3

Hi,

I am trying to add ASA  to CSM 4.3 via  Add  devices from network.

ASA  has been config  with http  server  ip and mask   then int

i get error  https

Connectivity Test Failed. Time Elapsed: 127 seconds.  Unable to Communicate With Device  No response to connection attempt to this device  Please verify the following and then retry this operation. (1) The device "IP address", Communication Protocol Mode and Port are correct.

(2) There is network connectivity between the CS Manager server and the device.

(3) The device is configured to accept http/https connections. To Discover IPS policies from IOS or IPS devices the http/https connections should be enabled otherwise IPS policy discovery should be disabled.

(4) The device is running.

CSM  server is conencted to ASA  interface.

Regards

Mahesh

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Unable to ADD ASA to CSM 4.3

One easy way to doublecheck is so see if can you can launch ASDM on the CSM server and connect to the firewall.

Both ASDM and CSM rely on the same https connectiivty.

1 REPLY
Hall of Fame Super Silver

Unable to ADD ASA to CSM 4.3

One easy way to doublecheck is so see if can you can launch ASDM on the CSM server and connect to the firewall.

Both ASDM and CSM rely on the same https connectiivty.

750
Views
0
Helpful
1
Replies