Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Unable to connect cisco 2950 using telnet

hi,

i have two switches (cisco 2950)  i am going to configure the swithc configuration using tlenet unfortunately i given Vlan IP same for both and copied to "running config" but it was came with some errors. After some time i was unable to connect to both swithes using Tlenet. iy gives an eror as "unablle to open port no 23".

please can anybody tell me how i can go back to old configuration. (still the switch was not rebooted)

thnks in advance

1 REPLY

Re: Unable to connect cisco 2950 using telnet

hi,

i have two switches (cisco 2950)  i am going to configure the swithc configuration using tlenet unfortunately i given Vlan IP same for both and copied to "running config" but it was came with some errors. After some time i was unable to connect to both swithes using Tlenet. iy gives an eror as "unablle to open port no 23".

please can anybody tell me how i can go back to old configuration. (still the switch was not rebooted)

thnks in advance

Hi,

Check out the below link for recovering the password and configuration in cisco 2950 switches hopw that help

http://www.cisco.com/en/US/products/hw/switches/ps628/products_password_recovery09186a0080094184.shtml

If helpful do rate the post

Ganesh.H

1150
Views
0
Helpful
1
Replies