Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

VMS RouterMC Device Import for VPN 3000 Concentrator Fails

I have been unable to import a VPN 3000 Concentrator into VMS Management Center for VPN Routers. When importing the device it requests an enable password for the VPN. I would assume that this parameter is ignored if the VPN does not have an enable password. However, at the end of the import I receive the following error - Error: 1. Error logging into the device. Your enable password might be incorrect or there might be an error in the enable prompt (see Troubleshooting Import Problems in the online help for details).

Any ideas?

1 REPLY
Silver

Re: VMS RouterMC Device Import for VPN 3000 Concentrator Fails

If the standard device prompts have been customized, you can configure Router MC to recognize the customized device prompts.

http://www.cisco.com/en/US/products/sw/cscowork/ps3994/prod_release_note09186a00801e71cc.html

126
Views
0
Helpful
1
Replies
CreatePlease to create content