I'm trying to locate the MIB/OID responsible for showing all current/active connections so that I can configure MRTG to monitor. Nothing is generated when I do a MIB walk that would be responsible for this. I'd really appreciate some help on this. I have looked everywhere on Cisco's web site with very little luck.
Take note of the dependencies for this MIB, you will need to download and install the ALTIGA-GLOBAL-REG and ALTIGA-MIB MIB's first before this MIB will work. Then just walk the entire SESSION-STATS MIB and you'll see all the info you want. Things like:
alActiveSessionCount.0 = 2 (current number of sessions)
alActiveSessionUserName.1 = admin
alActiveSessionUserName.2 = glenn
Then for .1 and .2 (the admin HTTP session and my VPN client tunnel respectively) there's more information than you could ever want. Hope that helps.
Re: VPN 3015 - MIB for showing active connections?
Hi to all, I have just joined this forum and I have a similar problem. I also need to configure our NMS - HP Openview Network Node Manager, to monitor all current/active VPN sessions. In fact I managed to find the MIB/OID that is responsible for this, which is .22.214.171.124.4.1.3076.2.1.2.17.2.1 series
and I can use the SNMP MIB Browser to browse the above oid tree but I cannot get a response when I try this out from the MIB Application Builder. I would like to do a menu using different OID's from the same MIB but all I get is the header and no output. I also get the error message
"this information is not available for my device".
DocumentationCode download linksGoalRequirementLimitationsSupported ISR
and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and
UCS-E Blades:Step by Step ConfigurationConfigure one of the connectivity
options to access the Cisco IMC from the n...
Firepower Threat Defense (NGFWv) on UCS E-series - Transparent Mode in
HA DocumentationCode download linksGoalRequirementLimitationsSupported
ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and
UCS-E Blades:Step by Step ConfigurationCo...
Question I am currently unable to specify "crypto keyring" command when
configuring VPN connection on my cisco 2901 router. The following
licenses have been activated on my router :