I have an ASA5505 with one site-to-site vpn policy to subnet "A", subnet "B" is the local subnet behind the ASA5505. I have a remote-access policy set which allows vpn client to remotely connect to the ASA5505. My desire is to allow the remote users to have access to both the local subnet "B" and the remote subnet "A". Remote Access users can see subnet "B" when connected but can not see subnet "A", I have "hairpinned" to allow cross interface communication for hub and spoke design but it did not work. Any ideas?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...