My laptop connects through ethernet to my WRT300N to braodband. Always worked fine. recently installed Cisco VPN client to connect to new 1841 Router in the office, and after about 2 hours it hangs, and I lose all connectivity. If I reboot the WRT300N, and reconnect the VPN client all is ok (for another 2 hours)
I had to set up port triggering on my WRT300N for the following ports:
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...