I have configured a VPN client connection in a PIX 506. The VPN client user gets a solid connection to the pix & an IP address assignment from the pool. But he is unable to connect to any address on the local network.
Most posible causes could be you need to enable NAT traversal on your firewall .
pix(config)#isakmp nat-traversal 20
If alreayd configured and still RA have no access check your nat exempt access-list to make sure you are allowing RA VPN pool network access to your LAN resources..
Regards
Jorge Rodriguez
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: