Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VPN Client not getting network connection

I have configured a VPN client connection in a PIX 506. The VPN client user gets a solid connection to the pix & an IP address assignment from the pool. But he is unable to connect to any address on the local network.

John G.

1 REPLY

Re: VPN Client not getting network connection

http://www.cisco.com/en/US/products/ps6120/products_tech_note09186a00807e0aca.shtml#Solution1

John,

Most posible causes could be you need to enable NAT traversal on your firewall .

pix(config)#isakmp nat-traversal 20

If alreayd configured and still RA have no access check your nat exempt access-list to make sure you are allowing RA VPN pool network access to your LAN resources..

Regards

122
Views
0
Helpful
1
Replies