VPN Concentrator - How to assign a different DHCP pool to each group?
I'm using a VPN concentrator and running into some trouble. I would like to be able to assign a different DHCP pool to each group. They can be within the same /24, if necessary, but I need to be able to control which smaller group they are put into. Ideally I would like the following:
Or something to that effect.
I have done the following:
+Selected the "use dhcp" and "use address pools" checkboxes.
+Created two separate DHCP pools (similar to those above)
+Gone in each Group configuration and set "DHCP Network Scope" to the first address in it's respective pool.
For some reason, though, addresses are always given out from a single pool. If I have two users connect, each to a different group, they will both receive addresses from the top pool in the list.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...