Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

VPN HW client, unable to reach GUI & SSH.

Hello.

We have a hardware client connected to our network with software 4.7.2.L working with LAN extension.

We can ping but we are unable to reach GUI and SSH on public interface.

Any ideas!

Regards.

Andrea

4 REPLIES
New Member

VPN HW client, unable to reach GUI & SSH.

Hi andrea.meconi@compaq.com,

  • have you checked the workstation ip address that could obtained a correct dhcp addresses (not APIPA) coming from the dhcp server? if it is correct then,
  • check the ip address of the workstation if it is correctly been configure to route packets to the other network/subnet.
  • check the policy or port filtering if you already have these enabled.
New Member

VPN HW client, unable to reach GUI & SSH.

Hello and many thanks for your help.

I can reach any other hw client on my network. For this I can only ping!

Regards.

Andrea

New Member

VPN HW client, unable to reach GUI & SSH.

Hi andrea.meconi@compaq.com,

Let me clear out of what's going on to the accessibility, you mean to say that you were trying to access the GUI and SSH from the external network and it didn't display or can't be accessable, respectively? If that is so, then,

  1. check your firewall inbound and outbound. It might be the port that being used by your GUI and SSH (Port 22) is not allowed.

-onin

New Member

Re: VPN HW client, unable to reach GUI & SSH.

You are right. I can reach the hardware client without any firewall. I have more than one clients and I can reach these without any problem from my workstation.

I'm going to replace it.

Thanks.

Regards.

Andrea

Sent from Cisco Technical Support iPad App

930
Views
0
Helpful
4
Replies
CreatePlease to create content