Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Vpn site to site configuration

Hi

I need configure a vpn site to site between

two cisco 800 series.

I configure it, but the tunnel is down :(

I need a manual to configure paramethres:

-vpn components: crypto map,ike,etc..

Thanks

3 REPLIES
New Member

Re: Vpn site to site configuration

Check this :

http://www.cisco.com/en/US/docs/security/vpn_modules/6342/configuration/guide/6342site3.html

its for 7200 series but it is simple :)

It will help you.

New Member

Re: Vpn site to site configuration

Thanks

It is possible in spanish??

I have the configuration enable,but where execute Troubleshooting test I have a problem:

"Ensure that the tunnel traffic was generate from one of the tunnel sources" and There is no respone from the peer VPN device"

Sorry from my very bad english.

New Member

Re: Vpn site to site configuration

One question.

The configuration of interface should be Atm0 or Vlan1???

With vlan1 the error display in vlan1.jpg

If select ATM0 the error dissapears but the vpn is down.See image atm0.jpg

Whit configuration is correct?

pd: The configuration of the mirror is exactly in two peers.

301
Views
0
Helpful
3
Replies