Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VPN3000 and RIP v2 authentication

Hi,

I have VPN 3000 box 3.6.7. I need to enable RIP v2 on outside interface. My problem is that I cannot find where I should specify that RIP v2 will use MD5 authentication and where I should specify RIP v2 authentication key. I look through the manual and could not find any references. It is hard to imagin that Cisco put RIP v2 on VPN 3000 but forgot to put authentication mechanism for it.

Appreciate a lot if somebody let me know whether it is possible or not.

Thank you

  • Security Management
1 REPLY
New Member

Re: VPN3000 and RIP v2 authentication

I don't think this is supported on the VPN 3000. As you should know already click the following URL to know the only two options possible,

http://www.cisco.com/univercd/cc/td/doc/product/vpn/vpn3000/4_0/config/interfac.htm#1019999

122
Views
0
Helpful
1
Replies
This widget could not be displayed.