I am using the Cisco 3.5 client to connect to a 3015 Conc.
From DOS I could run:
VPNClient Connect VpnProfile
And I get connect. But right before I get conencted I get a message:
"XYZ MainFrame access. For Authorized users only. Do you wish to Continue? y/n"
And I have to press Y to complete the VPN process.
I would like to run the VPN client through a batch file over night and every night to FTP a file to the mainframe. Is there a way to automate the "YES/Y" answer in the batch file or through a swtich key in the VPNClient command?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...