Web interface to config PIX

[logintck]

IS there any web interface to config PIX??

Thx ^^

[gfullage]

Sure, PIX Device Manager (PDM) has been around for quite a while now. If you have a recent PIX the software should already be installed, especially on the 501/506 line. Do a "sho ver" and if the second line of output says "PIX Device Manager ...." then the software is already there.

If not, you can get the software from here:

http://www.cisco.com/cgi-bin/tablebuild.pl/pix

and read the install notes here:

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pdm/index.htm

Have fun.

[logintck]

Thx Reply

I check my PIX, PDM (1.1.2) has been installed before

but how to access it by web? ( After I read the note, I don't understand)

Thx ^^

[rdash]

in your web browser "http://ip address of pix inside interface" or change inside interface to management interface if you have one. I would suggest upgrading the pix OS and PDM two different downloads.

[logintck]

I have tried to https://Interal IP of PIX

but fail

I need to enable http?

> http server enable

THX

[rdash]

The following commands should be issued.

http server enable

http (ip address of workstation pdm is to be used from) 255.255.255.255 inside

pdm location (ip address of workstation pdm is to be used from) 255.255.255.255 inside

That hoepfully should get you working.

[logintck]

Thx!! It works now

pdm location (ip address of workstation pdm is to be used from) 255.255.255.255 inside <= what is that mean??

[rdash]

In pdm 3.0(1) another command is added that is pdm location that addresses locations where pdm is available from. the mask 255.255.255.255 means only this address and only the inside interface.

[jgwiesner]

use https://

There is no auto-redirect to the secure page.

Jon