Why do my firewalls only use the domain username and password for login and enable passwords, not a different enable password like my switches do? The RADIUS config looks the same...
Cisco firewalls require only one level of password i.e. the domain username and password are used for both logging in as well as reaching global configuration mode.
We have multiple Cisco network devices set up which authenticate to our Windows domain controller using NPS (Windows 2008 R2). The switches we have set up all function exactly as we would hope as they require your domain username and password to login to the device. They then require a separate password when you use the enable command, this is stored in Active Directory:
Firewalls (as they currently are):
With the firewalls however, they require your domain username and password first, and then your domain password again when using the enable command. I want the firewalls to use the enable level password that the switches currently use instead of the domain password again. The current configuration look like the following:
Current switch configuration:
aaa authentication login default group radius local
aaa authentication enable default group radius enable
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...