Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Configuring Site to Site VPN between Cisco ASA and Cisco Router

This video explains the process of configuring Site to Site VPN between Cisco ASA and Cisco Router.

11 Comments
New Member

excellent video!!!

New Member

Nice Video,  very informative and good step by step process.  Well done!!

New Member

woww great..thanks 

New Member

Amazing walkthrough.

If you have trouble establishing VPN on one of the new 2nd generation ISR devices make sure that you enable PFS in your IPSec Policies (Crypto Map Sets) page in CCP or use CLI to do so.

New Member

Eric,

Thanks for the extra note about PFS needing to be configured in CCP as this is what was catching me up.  Without it, I needed to generate traffic from the ASA network side before the tunnel would come up!

I hope that they upgrade the video to include the newer ASDM interface and options and the appropriate configuration with CCP.

Prabhu, thanks for posting the walk through guide and video!

New Member

Thanks Prabhu . It was an excellent video and very nicely explained .

Looking forward to see more videos of configurations with CCP.

New Member

Hi Prabhu,

This is a very nice video. Short and simple to understand. Looking for some troubleshooting scenarios for the issues raised for TAC support.

New Member

This is realy nice and clean video for the novice users to understand the vpn ....

New Member

I can get the tunnel to come up but I cannot pass any traffic????

New Member

Check to see that your access lists are correct on both sides and permitting the proper subnets to talk.

New Member

shouldn't those be set by the wizard?

9111
Views
27
Helpful
11
Comments