The primary difference between P and UP is UP can do unified fabric on all ports, while the P can only do so on the expansion module. So I don't understand why you'd want to mix P and UP. Say you have eth1/20 that you configure as an fcoe port on the UP switch. If vPC failover occurs, eth1/20 which is a fixed port on the P won't be able to do FCOE, so you will have a service disruption.
That being said, I haven't done vPC between a P and a UP so I don't know for sure. But I have a strong feeling it won't be supported for the above reason.
The unmanaged mode is also known as Network only switching, which is introduced in Brazos release. It adds the flexibility for customer to use only network automation for service appliance.
If a device is configured a...
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...