I am planning to install an I/O (C7200-I/O-2FE/E)controller in 7206VXR, it doesnt have any I/O controller as its running with NPE-G1, do i need to bring down the router to install the controller or does it support OIR for controllers too.
The document shows either removing or replacing the I/O controller which is already installed but in my case i dont have any I/O controllers as the router is running with NPE-G1, all my configuration file is present in the NPE not in I/O controller.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...