Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASSOCIATION BETWEEN E1 AND SERIAL INTERFACE

I want to know how to associate an interface serial (s0 or s1) with the multiflex trunk module (MFT) in Cisco mc3810 IOS 12.1.

1 REPLY
Anonymous
N/A

Re: ASSOCIATION BETWEEN E1 AND SERIAL INTERFACE

Using the time-division multiplexing (TDM) cross-connect function, you can perform cross-connect in one of two situations:

1.Cross-connect two groups of DS0 timeslots from two controllers

1.Cross-connect pass-through traffic from either UIO serial port 0 or 1 to a trunk controller

http://www.cisco.com/univercd/cc/td/doc/product/access/multicon/3810soft/swcfg/sportcfg.htm#xtocid489913

194
Views
0
Helpful
1
Replies
CreatePlease to create content