Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

autocommand line command not working

I am trying to use the aux interface on one router to communicate with the aux interface on another router. Connected to each aux interface is a vt100 type terminal. I have autocommand telnet 60.20.70.6 2004 configured on one router's line 4 interface and on the other routers line 4 interface I accept all connections. My understanding is that when I type / send data to the async port on the router with the autocommand, a telent session should start creating a raw tunnel between the 2 async ports. The routers have no problems with telnetting from a command line to the async on the other router. I just can't get the autocommand to work. Any suggestions?

1 REPLY
Silver

Re: autocommand line command not working

Please post your question to "Remote Access" under "Network Infrastructure." You will find a better expertise there. This section is mainly for SNA over Cisco routers.

203
Views
0
Helpful
1
Replies
CreatePlease to create content