I have a Hyper-V 2012 R2 server (free version of Hyper-V) and I am in the process of deploying the Cisco 1000v virtual switch. I have a few questions, however:
1) My server has a single NIC with 4 uplinks. At the Hyper-V parent OS level, there is an external vSwitch not shared with the OS that uses the public IPs to go directly to the internet. And there is an internal vSwitch which is internal IPs but they are NAT'd via the UTM firewall to get internet connectivity.
The documentation states either 4 NICs with 1 uplink each or 1 NIC with 4 uplinks as a best practise, so I comply with this.
Should the VSM use a native Hyper-V switch and all my other VM's use the Cisco switch? In particular, see:
When I imported the template into SCVMM (2012 R2) and built the VSM, it did not pick up specific VM settings. I am not sure if my NIC configuration is correct, could someone take a screenshot of how this should look?
Lastly, how would I enable promiscous mode and netflow? And how would I setup SPAN ports?
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
In the Previous articles of ACI Automation, we are using Postman/Newman as the Rest API tool to automate the ACI Configuration.
In this article I’m going to discuss on usin...
One of the first steps in building your ACI Fabric is to go through Fabric Discovery. While Fabric Discovery is usually a straightforward process, there are various issues that may prevent you from discovering an ACI switch. This article wil...