If a blade chassis/encosure is going to use the Cisco 3130 blade switch, where does it fit into the overall architecture of the enclosure?
For example, the Dell M-1000e blade enclosure was designed to support Ciscos 3130 blade switches. But how do they fit into the overall architecture scheme? Normally, the blade servers connect to the I/O fabrics through the passive midplane...so where does the switch come in? Or does the switch replace the I/O fabrics?
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...