Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Blade Switch - Layer 2 Trunk Failover

Does anyone know from experience on a 3020 or GESM HP blade switch if downstream ports are recovered automatically when an uplink port recovers from a failure? I have seen references to the downstream ports being put in err-disabled state and was curious if they needed to be recovered manually even after the upstream recovers. Thanks.

1 REPLY
New Member

Re: Blade Switch - Layer 2 Trunk Failover

Yes, the downstream ports come up automatically when the upstream ports come back active.

212
Views
0
Helpful
1
Replies
CreatePlease login to create content