I am looking for a bootp configuration that the router will be a bootp server. The image for the terminal server will be on that router flash and when there is a bootp request from the lan interface then the router will serve the request and send the image
bootp server can't be configured on Cisco IOS. You can configure it as DHCP server though. The bootp device can probably get an IP address from the DHCP server. If you also configured your router as a TFTP server abd copy the image in the router's flash, you could probably get your bootp client to boot properly.
Hope this helps,
Harold Ritter Sr. Technical Leader CCIE 4168 (R&S, SP) email@example.com México móvil: +52 1 55 8312 4915 Cisco México Paseo de la Reforma 222 Piso 19 Cuauhtémoc, Juárez Ciudad de México, 06600 México
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...