Cache engine is getting restarted with every page fault event. I noticed that it stops working ( couldn't able browse internet ) just before page fault.Once i restart it , its works fine for another 3-4 hours and again same story.
could some one guide me on this.
I am putting the log which i traced on Cache Engine--
CACHE: LOG_LOCAL7 LOG_EMERG page fault
trace: 0x1c7b53 fp=0xab26ec0
trace: 0x3e706c fp=0xab26ef8
trace: 0x42aaaa fp=0xab26f30
trace: 0x1118cd fp=0xab26fac <=
trace: 0x113291 fp=0xab26fac
trace: 0x415eb8 fp=0xab26fd0
EXCEPTION: task tKmem tid 0xff8b200 version CE 2.31(0)
image 11:20:14 Feb 22 2001 (bbalagot)
Thu Nov 28 15:19:01 2002 CACHE: LOG_LOCAL7 LOG_NOTICE ======================
Thu Nov 28 15:19:01 2002 CACHE: LOG_LOCAL7 LOG_NOTICE System restarted by Exception
Thu Nov 28 15:19:01 2002 CACHE: LOG_LOCAL7 LOG_NOTICE System booted from "flash"
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...