Can I Configure an Etherchannel from 2 Separate Modules?
I want to setup a Gigabit channel on two separate modules, for redundancy. The channel would go from a Catalyst 6509 to a Catalyst 4006 using the 8-port Gigabit module on the Catalyst 6509 and the two Gigabit ports on the Supervisor Engine on the Catalyst 4006. For example, set port channel 3/1, 4/1
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...