The answer to the question in your title is no. But then the question changes to include APPN on the VSE system. With APPN this could work if the VSE system is defined as an End Node (NODETYPE=EN). There is also a small corner case possibility where the VSE system could use PU Type 2.1 (LEN - Casual Connect) for LU Type 6.2 sessions to the z/OS system.
In order to use snaswitch, not only must the VSE system be configured as an End Node, it must also be configured to accept a non-"session services extension capable" network node server. This is done by specifying a network node server list with SLUINIT=OPT. In other words, both the snaswitch and the casual connect solutions require that the only types of sessions required by the VSE system be LU 6.2.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...