Cannot connect to internet on member switch in 2960 switch stack

[tariq-rashid]

I'm not sure this the right forum, so please forgive me.

My setup is this:

1 5515-x ASA connected to ISP

2 2960-s switches in a switch stack

The scenario

Master Switch  is trunked to ASA directly for internet access

The good:

Ports in the Master Switch all work. I can plug my device in and it will get an internet connection

The bad

I connect to a port in the Member Switch and I get nothing.

What could I be doing wrong. The Master Switch's configuration applies to all Member switches, right?

Other than needing to change my default route to the trunked interface(I currently have it set to an ip address, no bueno). Am I missing something?

[Reza Sharifi]

The Master Switch's configuration applies to all Member switches, right?

Yes, it does. The config applies to the entire stack.ht

I connect to a port in the Member Switch and I get nothing.

Are all switch ports in the same vlan?

It maybe that the ports that are not working are in a different vlan that is not allowed on the trunk to the ASA.

HTH

[musikman1988]

Hi Bro,

Did you have a solution for it?

The 2960 stack member switch also have some strange issue.

I come cross some issue about cisco ISE cert, but the environment is similar to your.

I have a stacking switch (4 * 2960X), in MASTER switch everything is working well, not in MEMBER switch it has something wrong.