Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CatOS to IOS Conversion

In preparation of my 6500 CatOS to Native IOS conversion, I ran my configuration through the online configuration tool. While it did a good job, there was a few lines that didn't convert which require manual editing.

My question is that I can't find equivalent commands to convert the following statements:

set qos wrr 2q2t 5 255

set qos wrr 1p2q2t 5 255

set qos wrr 1p2q1t 5 255

Anyone know equivalent commands to these?

Thanks,

Joe

1 REPLY

Re: CatOS to IOS Conversion

Joe,

The following link has the info you need. Use this document to calculate the corresponding values in your case.

http://www.cisco.com/warp/public/473/152.html

For eg, the 1st statement in your config should transalate to as follows in the IOS mode.

CatOS:

set qos wrr 2q2t 5 255

Native IOS:

int

wrr-queue bandwidth 1 51

HTH

Sundar

201
Views
0
Helpful
1
Replies