Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 2600 with NM-1A-T3 DS3 ATM Module

I had recently just purchased a Cisco 2600 router, a DS3 ATM module, a 1 port Serial adapter separately.

Searching through the Hardware/Software Matrix, shows that IOS 12.2(2)T is one of the appropriate software to be used for this combination.

Cisco 2600

NM-1A-T3

WIC-T1

However, after loading in the IOS, the router display an error message "%PA-2-UNDEFPA: Undefined Port Adapter type 426 in bay 1"

Please advise what is the best solution to this issue.

1 REPLY
Anonymous
N/A

Re: Cisco 2600 with NM-1A-T3 DS3 ATM Module

Requires an IOS "Plus" or Service Provider ("-p-") feature set

169
Views
0
Helpful
1
Replies