Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco ASR 100X Routers

Mind filling me in on what modules I actually need, I keep reading the documents but it gives me the feeling that they may not do what I want to acomplish.

The router will have two ISPs connected via either 1Gbit or SPF, then it will connect with a 5585 via SPF, which modules do I need to cover the ports?                  

  • Server Networking
6 REPLIES
Cisco Employee

Cisco ASR 100X Routers

Which ASR model you are talking about? It depends on model and SIP module being used. Very open question,please tell us the model you are looking for or check the ASR1K datsheet.

New Member

Cisco ASR 100X Routers

ASR 1006 is the one Im aiming for, just now need to know everything I need

Cisco Employee

Cisco ASR 100X Routers

Hi Ethan,

ASR1006 is a modular chassi router. You need the following right for day 1 :

1. Chassis with PS and related Fans.

2. RP : Route processor for the chassis

3. ESP - Embedded switch processors.

4. SIP - SPA interface processors for 10G or 1G and related SFP's.

http://www.cisco.com/en/US/prod/collateral/routers/ps9343/data_sheet_c78-443175_ps9343_Products_Data_Sheet.html

Please see all the ASR1006 related datasheet here :

http://www.cisco.com/en/US/products/ps9438/index.html

Cheers,

-amit singh

New Member

Cisco ASR 100X Routers

Thanks for the response

SPA-1X10GE-WL-V2 <- 10GB SFP+
SPA-8X1GE-V2 <- 1Gbits

So the two cards would give me what I need?

Ethernet to my internet gateway that the ISP Provides, and the 10GB SFP+ port I need to connect to my 5585?

Cisco Employee

Cisco ASR 100X Routers

Yes Ethan, you are correct. You need to SPA's for this funcationality. I think ASR does not have any combo 1G+10G SPA so you need 2 of these for your solution with the required SFP's.

Hope this helps.

-amit singh

New Member

Cisco ASR 100X Routers

Ive done som research and it doesnt seem to work the way I want it to

The 10Gbit interfaces dont seem to be a standard SFP+ port, what I had planned to to was interconnect my router/firewall using the SFP+, but the receiver modules dont seem to match up.

I have a fibre gateway, it does offer SFP+ ports off that gateway from the ISP which I planned to connect to my Router, then router to firewall.  Mind sharing what SPAs may support that?

803
Views
0
Helpful
6
Replies